A Sanisplit is designed to collect the discharge of sanitary fittings and kitchen appliances, and pump it under pressure vertically and horizontally. One unit can be located per bathroom or kitchen, and can deal with the discharge of washing machines, dishwashers, basins, showers, baths and toilets.

A Sanisplit is designed to collect the discharge ofsanitary fittings and kitchen appliances,and pump it under pressure vertically and horizontally (see charts for height and distances). A unit can be located in a bathroom or kitchen,and can deal with the discharge ofwashing machines,dishwashers,basins,showers,baths and toilets.

Fitting space needed
Allow a gap of at least 10cm (4") either side ofthe unit for disconnection ofthe macerator section and draindown from the pump section. Any shower or bath waste fitting must be at least 20cm (8") above the level of the base of the Sanisplit. Install a non-return valve between the shower or bath and the macerator.

Inlet Piping
ALL PIPEWORK INTO THE UNIT MUST HAVE A GRAVITY FALL as the pump cannot suck.
The WC connection can be made remote (with a toilet pan connector through an adjoining wall for example).
Push fit piping can be used on the inlet side.

Discharge piping
Use 32m or 40mm solvent weld discharge pipe.
Use of22mm pipe or 90 degree bends may damage the unit and will invalidate the warranty.
Use swept bends where possible,or two 45 degree bends.Your Sanisplit will pump horizontally and vertically.
Discharge can be from the left rear,or left side of the unit.
Pipes can be hidden behind a 50mm or 60mm stud wall, or chased into existing brickwork.
All pipework must be installed as per manufacturers specification with support brackets.
Lag pipework where there is a risk offreezing.

Electrical
Your Sanisplit must be wired into a fused,unswitched fixed wiring connector (5 Amp Fuse).Disconnect from the electricity
supply before attempting to service the unit.

Flow Rates
Maximum head is 11 metres vertically,or 80 metres horizontally.If both vertical and horizontal pipes are used many factors will affect performance such as number of bends and length of horizontal and vertical pipework. For this reason, no accurate performance calculation formula is possible.

• FEATURES:

  • Power supply: 230 Volt / 50Hz / Single Phase
  • FULLY AUTOMATIC: Macerates waste water automatically pumping it upto the sewer line
  • One-way Valve: Built-in prevents the pumped water returning to the unit
  • Internal Plumbing Option: Means you don't see ugly discharge pipes
  • Muti-Purpose: Macerator and Grey water pump comes complete with blanking caps. Can be used for 1 basin only or complete bathroom with toilet
  • Complies with international standards EN12050-2, EN12050-3, EN12050-4
  • Split System makes maintenace easy and simple without disconnecting pipes, WC, without tools or expensive service technicians